Moates.Net Logo
(0)
. 00

My Account
Tuning Solutions for the Modern Gearhead
 
Ostrich
Untitled Document

Here's how you install the Ostrich:

1) Get on the website here in the 'software and drivers' section and download and unzip the 'USB Drivers' file. Remember where you put it.

2) Plug the Ostrich into the USB port of your PC, and point the operating system to the previously located USB Driver directory and install the drivers. See the USB Driver Installation Guides here on www.moates.net for further guidance in this regard.

3) Go into the drivers and set the COM port of the USB to Serial Converter (under Ports in the Device Manager of the Windows Control Panel). Set it to COM3 or COM4. Override any warnings against 'port in use' or any of that nonsense. Again, refer to the USB install guides for more info.

4) While in the port settings, set the latency to '1' (default=16). This will speed it up dramatically.

5) Use TunerPro RT or a similar program to upload a binary to the Ostrich, and verify that it is uploaded correctly.

6) Hook it up to the vehicle, and go to town. When installing the ribbon cable where the chip normally goes, orient the red stripe so that it faces where the chip notch or arrow (pin #1) would normally face.

Note: If you have the car off, and the Ostrich is hooked up to the car's ECU, then sometimes an upload/verify won't work right. Just turn the car on, or disconnect the Ostrich during the initial upload, and everything should be fine.

There are jumpers inside the Ostrich, depending on how many pins / memory size you are emulating to.
The following pictures illustrate three different ones: 24, 28, and 32-pin. The 32-pin is only used for Ford EEC-V applications right now.

24-pin (with associated pictures for an installation where the original chip was a 2732A in a 1227747-style GM ECM):
Here's the jumper settings, set for 24-pin emulation:

Here's the socket that is soldered in the ECM. Note the direction of the notch (to the right) indicating where the original chip pin #1 would go:

Here's one way to do it, first right before insertion and then after it is snapped down in. Really it is preferable to use a ZIF socket here. Notice the 24-pin socket that is stacked onto the bottom of the regular 28-pin emulation cable. You can just use the 28-pin with the extra 4 pins hanging over as well. Note the red stripe toward where the notch would normally go:

28-pin Installation using the G1 chip adapter, similar to that used in a 1986-92 TPI GM ECM:
Check out the jumper settings. Note that this is the configuration that the Ostrich is shipped with, and works for the majority of the applications.

Note the direction of the notch on the chip, despite the direction of the ZIF handle. This is counter-intuitive for many, and is relatively unique to the G1 / TPI-style adapter due to spatial constraints in the ECM housing:

Now we take the chip out, and put the emulation cable in. Note the red stripe and how it is oriented compared to the notch on the chip that was there before:

32-pin Jumper Settings, presently only used for EEC-V applications:


Copyright © 1999-2018 Moates.net